DMX512 is a protocol used to control dimming equipment, color chargers, automated lighting and other related devices.
Permanent DMX512 control wiring installed in an entertainment venue can make such devices easier to install and use.
DMX512 Control Receptacle Plates provide a logical termination point for DMX512 control wiring that is installed
in conduit. Electrical codes do not normally require conduit for low voltage control wiring. Flexible cables
are typically used to interconnect DMX devices in addition to or in the place of permanent wiring, when equipment
is regularly reconfigured.
|
IPS-SW-101 Lighting Console Connection Plate.
|
|
- Use to connect DMX512 controllers (console)
- Mount on standard 4x4 wiring box
- Easy terminal strip connectors
|
|
IPS-SW-102
|
|
- Use to connect devices controlled by DMX512 (dimmers)
- Use in the middle of a wire run
- Mount on standard 4x4 wiring box
- Easy terminal strip connections
|
|
IPS-SW-103
|
|
- Use to connect devices controlled by DMX512 (dimmers)
- Use in the middle of a wire run
- Mount on standard 4x4 wiring box
- Easy terminal strip connections
|
|
IPS-SW-104
|
|
- Use to connect DMX512 controllers (console)
- Use in the middle of a wire run
- Mount on standard 4 x 4 wiring box (Mounts on standard 4" square electrical box 21/8" deep minimum RACO #231, #233 or equal.)
- Easy terminal strip connections
|
|
DMX Termination
|
|
|
Function
|
Terminal Number
|
XLR Connector Pin Number
|
Wire Color
|
|
GND
|
1
|
1
|
Shield (drain)
|
|
DMX -
|
4
|
2
|
White with Blue
|
|
DMX +
|
5
|
3
|
Blue with White
|
|
TALK -
|
2
|
4
|
White with Orange
|
|
TALK +
|
3
|
5
|
Orange with White
|
|
If you have a technical question about IPS, please email
IPS@rosco.com
|
