|
How
to do it ?
1 Carve 6" bead foam block into adobe brick.
2 Mix FoamCoat with coarse sand and tint appropriately.
3 Coat styro with multiple coats of FoamCoat mixture.
4 Let dry.
5 Carve joint and irregular stone edges as indicated in photo.
6 Build up "plaster" layer edge and feather over surface of
"bricks" to coat entire piece.
7 Make final layer of mud with combo of FoamCoat and Tough Prime.
8 Apply as indicated.
9 Faux paint cracks in "plaster".
10 Faux paint edges of "mud".
11 Paint as indicated.
12 Distress as indicated in photo.
|
