INSTRUCTION MANUAL

A. Before You Begin
B. Assembling the ImagePro™
1. Mounting the Z-Glass Filter
2. Attach the iPro Slide
C. Installation into the Luminaire
D. Powering the ImagePro™
E. Obtaining iPro Slides
F. Make Your Own iPro Slide

ASSEMBLING THE IMAGEPRO™

Z-Glass

If it is not already installed, the Z-Glass filter must be mounted onto the backside of the ImagePro plate. Position the filter within the four bolt posts, using the D-Washers to center the glass over the aperture cut out. The glass should be installed with the metal ring flat against the ImagePro™ back plate and the flush surface of the glass facing up.

Place the washers on next and then tighten down the lock nuts onto the flange of the Z-Glass ring.

Keep the Z-Glass free of dust and fingerprints. To clean it, use a soft, lint free cloth and gently wipe the surfaces. Do not use cleaning fluids or solvents of any kind. DO NOT ATTEMPT TO USE THE IMAGEPRO WITHOUT THE Z-GLASS INSTALLED. THIS WILL CAUSE PREMATURE FAILURE OF THE SLIDE AND MAY CREATE A FIRE HAZARD.

Attaching the iPro Slide

The iPro slide is pre-assembled for easy installation with its protective filter and image layer properly oriented. Line up the three key slots on the back of the slide with the key buttons on the front plate of the ImagePro. Drop the slide onto the buttons. Then, using mild pressure, slide the slide down until it stops, locking onto the plate.

Avoid touching either of the plastic films on the front or back since fingerprints may damage the slide. To clean dust and fingerprints off an iPro slide, use a soft, lint free cloth and gently wipe the surface. Do not use cleaning fluids or solvents of any kind. Protect the iPro Slide from contact with water or the image may be damaged.