INSTRUCTION MANUAL

A. Before You Begin
B. Assembling the ImagePro™
1. Mounting the Z-Glass Filter
2. Attach the iPro Slide
C. Installation into the Luminaire
D. Powering the ImagePro™
E. Obtaining iPro Slides
F. Make Your Own iPro Slide

INSTALLING INTO A LUMINAIRE

The ImagePro™ backplate has a unique design insuring that it will fit into the iris slot of many popular luminaires. Based on the same design as Rosco's best selling Universal Iris Slot holder, the ImagePro™ is designed to fit into the Altman Shakespeare, ETC Source Four and Source Four Zoom, Selecon Pacific, and Strand SL.

Before attempting to install the ImagePro™ into a luminaire, slide back the cover over the iris slot as far as possible. On certain luminaires it may be necessary to remove this cover altogether.

Insert the ImagePro into the Iris slot with the fan box pointing towards the front of the luminaire. Initially, you may have to tilt the light down to allow the ImagePro™ to clear the yoke of the luminaire. Once installed, you can focus the luminaire in any direction you require. Make sure that the ImagePro™ drops all the way down into the fixture, and is aligned vertically, not set at an angle. (If the image appears cut off when projected, the ImagePro is not seated all the way down in the iris slot. Gently wiggle it until it drops down completely.) Rotate and focus the lens barrel of the luminaire for a sharp, properly aligned projection.

Use caution when rotating the lens barrel to prevent the ImagePro from falling out of the luminaire. A ring is located on the front of the ImagePro to allow a safety cable to be used.

Note: Installing Into A Selecon Pacific
The iris slot in the Selecon Pacific is slightly different from other luminaires. At the back of the iris slot are shallow guide tracks. When installing the ImagePro, align the metal tabs on the top and bottom of the ImagePro™ backplate with these guide tracks. Slowly lower the ImagePro down into the iris slot, insuring that both the top and bottom tabs of the plate track into the guides.

ELECTRICAL CONNECTION

The ImagePro requires an electrical circuit to power its fan. You may use a either a dedicated circuit (non-dim or dimmable) or alternately you can two-fer the ImagePro™ in with the dimmer powering the luminaire. A Hybrid Two-Fer with one female parallel blade connector and one female stage pin connector is available from Rosco (part number 265 25500 0000, 120v US Stage Pin configuration only). Connected in this way, the ImagePro does not use an additional power circuit. Dimming the light will slow the fan speed (and reduce its noise) but since the heat generated by the lamp at lower intensities is also reduced, this does not have a negative impact on the life of the iPro Slide. In fact, at 50% intensity, the life of the iPro Slide is virtually infinite.

DO NOT ATTEMPT TO USE THE IMAGEPRO IF THE COOLING FAN IS NOT WORKING PROPERLY. THIS WILL CAUSE PREMATURE FAILURE OF THE SLIDE AND MAY CREATE A FIRE HAZARD.

Specifications
Fan: 12v .15mA (CE)
Transformer: 120v, 1000mA; 240v 1000mA (CE)