|
How to apply Roscoflamex W40
Roscoflamex W40 is intended for use on untreated wood surfaces. No other coating
(paint, clear acrylic, polyurethane, stain, etc.) should be applied on top of
Roscoflamex W40. While a paint coating will not diminish the effectiveness of
the W40, some paint and coatings may not adhere properly. If the wood is to be
painted, test accordingly. Also, some coatings may be flammable when dry.
Roscoflamex W40 will only treat the substrate and provides no protection
against the possible fire hazard created by a flammable coating applied on top
of the treated wood. Consider using Roscoflamex P50 as an additive when
painting with Roscopaint. Penetrating stains will not alter the effectiveness
of the W40. Do not use water-based clear urethanes or clear acrylics over W40
as clouding may occur.
DILUTION:
Roscoflamex W40 is used straight out of the bottle.
DO NOT DILUTE
.
APPLICATION:
-
Immersion:
This method insures the greatest saturation and is the recommended method fo
treating wood. Immerse the wood for 2 hours in warm Roscoflamex W4
(100°F) or 8 hours at room temperature.
-
Brushing:
Brush on three coats of warm W40 to both sides of wood. Apply enough solution to
ensure that the material is wet. Allow at least 5 minutes between coats. Clean
brushes thoroughly after use.
-
Spraying:
Spray 3 coats of warm Roscoflamex W40 uniformly to both sides of wood using a
Hudson-type sprayer. Allow at least 15 minutes between coats. Clean sprayer
thoroughly after use.
STORAGE:
Store Roscoflamex W40 only in non-metallic containers. When metal sprayers are
used, they should be thoroughly cleaned immediately after use, including
nozzles and accessories. Avoid use of metal buckets or paint containers when
possible.
COVERAGE:
Wood, plywood: 110 sq. ft./gal. in three spray coats. Corrugated paper: 300 sq.
ft./gal. Acoustical tile and cellulosic board: 60 sq. ft./gal. in three spray
coats.
WARNING: Use only with adequate ventilation. Do not take internally. Do notstore in extreme heat or allow to come in contact with strong acids. Closecontainer after each use. Do not transfer contents to another container. Do notstore in metal containers as Roscoflamex may corrode. Wash hands after use. KEEP OUT OF REACH OF CHILDREN.
W40 Quick Tips
-
W40 is intended as a solution to flame retarding raw wood. Paints and sealers
may be applied on top but special considerations must be taken for adequate
adhesion over the W40. Also, avoid using water based clear sealers on top of
W40 as clouding may occur.
-
Hay can be effectively treated with W40. However, it is necessary to insure that
all strands of hay have been treated. As it is often not practical to immerse
full bales, it is recommended that bales be separated into smaller sections,
immersed and treated individually and then assembled back into bale form.
-
Live trees or plants, especially Christmas trees or wreaths cannot be treated
with W40.
Contact Rosco for more information or technical support on treating your scenery
for flame retardance.
|
Specifications
|
|
#07940
|
Roscoflamex W40
|
|
