FlexCoat®

A flexible, flame retardant covering for a wide variety of foams and other surfaces

Rosco FlexCoat is a non-toxic, water-based coating for polyurethane foam, Styrofoam and ethafoam, as well as other surfaces. Its 100% acrylic formulation provides excellent adhesion to a wide variety of substrates. FlexCoat contains no plasticizers, so will not become brittle with age or exterior exposure. It is compatible with Rosco Scenic and UV Paints used either as tints or surface coatings. FlexCoat is weather resistant and provides a Class "A" fire rating over most substrates.

Please note: This product is temporarily unavailable in the EU. Updates are being made to our Safety Data Sheets to ensure compliance with European documentation standards. We apologize for any inconvenience this may cause.

Application: Apply by brush, roller or a variety of sprayers. Stir well before each use. Thinning is possible but not recommended as it reduces the ability to achieve a heavy film with good vertical hold. All surfaces must be uniformly coated and free from voids to assure flame retardance.

Suggested Use: Excellent for use as a flexible protective coating over all types of foam. It is especially useful on foam scenery and props which undergo excessive handling or protracted tours. It, also, performs well over concrete, primed metal and primed wood. FlexCoat does not add significant additional weight to the finished product.

Surface Preparation: All surfaces should be clean, dry and free of dust and grease before application.

Coverage: Varies with application method and substrate. Approximately 250-300 square feet (23-28 square metres).

Dry Time: Varies with thickness of coating, temperature and humidity. Approximately 1-8 hours. Allow 24 hours for complete cure.

Clean-Up: Easy clean-up with soap and water.

Shelf Life: Minimum 12 months.

Packaging 1 Gallon and 5 Gallon (3.79L and 18.95L)

CAUTIONS: Do not apply when surface or air temperature is below 50°F (10°C). Protect against freezing. Flexcoat will freeze and become unuseable at temperatures below 32°F (0°C). Do not take internally. Use with adequate ventilation. KEEP OUT OF REACH OF CHILDREN.

All technical data, recommendations and service are accurate to the best of our knowledge. Rosco assumes no responsibility for the results obtained or damage incurred from use by the buyer in whole or in part since method of application and its use is beyond our control.

Product Number

150 07120 0128

FlexCoat® - Gallon

150 07120 0640

FlexCoat® - 5 Gallon

FlexCoat® Data Sheet

FlexCoat® - SDS

FlexCoat® FAQ's

The Rosco Guide to Scenic Finishes

Creating Textured Surfaces

Case Study: Adaptive Halloween Costumes For Children With Disabilities

Case Study: How To Create Creepy Halloween Scenery That Will Survive To Haunt Again