Available in 9 brighter than normal colors which "glow" vividly under ultraviolet lights, Rosco Fluorescent Paints can create a wide range of exciting effects. They can be used to create special effects using ultraviolet black light or combined with other Rosco Scenic Paints to make the colors more vibrant. Fluorescents use the same high quality, water-base, vinyl acrylic binder found in Off Broadway Paints. It is suitable for use on most surfaces after the surface has been properly prepped. Try using Rosco Fluorescent paints when matching the brightest colors in the Pantone Color Matching System or to achieve astounding 3-D effects.
Binder Type:Vinyl Acrylic
Dilution: Fluorescent Paints should be used straight out of the can. They can be diluted with water if necessary, however this will reduce the hiding power of the paint and may reduce the brightness of the "glow".
Surface Preparation: Surfaces should be clean, dry and free from dirt and grease. Prime porous surfaces, except fabrics, using Rosco Tough Prime. If painting a new plaster surface, prime wall with a commercial primer/sealer designed for raw plaster. Then use Rosco Tough Prime as a final preparation. Use a white base coat to achieve the most dramatic color effects.
Application: Stir contents well before use. Apply by brush, roller, or spray gun. Apply in thin uniform coats, using a good quality brush or roller. Use overlapping strokes, keeping a wet edge.
Film Thickness: 2 mil. dry film.
Coverage: Approximately 300 sq. ft. per gallon (28 sq. m. per 3.79L), depending on application method, substrate and thickness of the application.
Avg. Dry Time: At 75°F (24°C). Dries to the touch in 30-45 minutes. Can be recoated in 1-2 hours.
Clean-up: Soap and water.
Shelf Life: Minimum shelf life for unopened, sealed paint is approximately 24 months when stored in a temperature controlled location.
Packaging: Gallon, Quart and Pint Cans (3.79L, 0.946L and 0.473L).
* Fluorescent pigments will degrade from prolonged exposure to ultraviolet light. Avoid direct sunlight where possible.
** Invisible Blue is a milky white paint that fluoresces to a pale blue under blacklight. When painted over light colored surfaces, Invisible Blue is difficult to detect. However, it can be seen when painted over dark or black colors.
All technical data, recommendations and service are accurate to the best of our knowledge. Rosco assumes no responsibility for the results obtained or damage incurred from use by the buyer in whole or in part since method of application and its use is beyond our control.
|150 05779 0016
150 05779 0032
150 05779 0128
|Fluorescent Paint White - Pint
Fluorescent Paint White - Quart
Fluorescent Paint White - Gallon
|150 05780 0016
150 05780 0032
150 05780 0128
|Fluorescent Paint Red - Pint
Fluorescent Paint Red - Quart
Fluorescent Paint Red - Gallon
|150 05781 0016
150 05781 0032
150 05781 0128
|Fluorescent Paint Orange - Pint
Fluorescent Paint Orange - Quart
Fluorescent Paint Orange - Gallon
|150 05782 0016
150 05782 0032
150 05782 0128
|Fluorescent Paint Yellow - Pint
Fluorescent Paint Yellow - Quart
Fluorescent Paint Yellow - Gallon
|150 05783 0016
150 05783 0032
150 05783 0128
|Fluorescent Paint Green - Pint
Fluorescent Paint Green - Quart
Fluorescent Paint Green - Gallon
|150 05784 0016
150 05784 0032
150 05784 0128
|Fluorescent Paint Blue - Pint
Fluorescent Paint Blue - Quart
Fluorescent Paint Blue - Gallon
|150 05785 0016
150 05785 0032
150 05785 0128
|Fluorescent Paint Invisible Blue** - Pint
Fluorescent Paint Invisible Blue** - Quart
Fluorescent Paint Invisible Blue** - Gallon
|150 05786 0016
150 05786 0032
150 05786 0128
|Fluorescent Paint Pink - Pint
Fluorescent Paint Pink - Quart
Fluorescent Paint Pink - Gallon
|150 05787 0016
150 05787 0032
150 05787 0128
|Fluorescent Paint Gold - Pint
Fluorescent Paint Gold - Quart
Fluorescent Paint Gold - Gallon
|150 05700 0KIT
||Fluorescent Paint Kit
9-piece kit contains one ounce samples.